Best Gas Hot Water Tanks

Please Note:

1、When install the water heater please do not over tighten the connectors and pipes to prevent it from bursting and leaking.

2、The exhaust and top will get hot, please check around area for flammables, especially gasoline or other vapors which may ignite. Please make sure there are no foreign objects around the portable tankless water heater or have fallen into the top.

3、A gas leak detection is needed before use and please do not use flame for leak detection. Soapy solution, gas detectors, etc. are recommended to detect leaks.

4、Please use only liquid propane as fuel and use it in a well-ventilated place.

5、Please make sure there is enough water pressure. If the water pressure is below 2.5 PSI, the water heater cannot be ignited.

6、If the outside temperature is around or below freezing(0℃/32℉), please ensure to drain out the water after each use to avoid internal damage to the heat exchanger.

7、This water heater is not suitable for high altitude areas over 3300 feet and strong wind conditions.

Product Description

Features ENERGY STAR Qualified Energy Factor of .82 for Natural Gas and Propane Certified for Installation in Manufactured (Mobile) Homes Leak detection shuts off water to unit to limit property damage Enhanced scale detection lessens possibility of serious, long-term damage to unit Temperature lock prevents accidental or unauthorized changes to water temperature Complies with South Coast Air Quality Management District 14 ng/J or 20 ppm NOx emission levels Rinnai Value Series Tankless Water Heater Product Warranty Dimensions Width: 14 Inches Height: 23 Inches Depth: 9 Inches Weight 45.6 Pounds Ignition Direct Electronic Hot Water Capacity 0.26 to 6.6 GPM Minimum Activation Rate 0.4 GPM Minimum/Maximum Gas Rate (Input BTUs ) 10,300 150,000 Energy Factor 0.82 for Natural Gas and Propane Energy Star Yes Approved Gas Types Natural Gas or Propane Temperature Settings 98F – 140F with MC-91-2US 98F – 160F with MCC-91-2US Type of Controller MC-91-2US (included) MCC-91-2US (optional for Hydronic Applications) MC-100V-1US Deluxe Controller (optional) BC-100V-1US Bathroom Controller (optional) Ultra Lox NOx Yes Electrical AC 120 Volts, 60 Hz Electrical Consumption Normal: 76 Watts Standby: 2 Watts Anti-Frost Protection: 120 Watts Service Connections Gas Supply: 3/4 Inch MNPT Cold Water Inlet: 3/4 Inch MNPT Hot Water Outlet: 3/4 Inch MNPT. Turn off gas supply and 120 V power supply

From the Manufacturer

Features ENERGY STAR Qualified Energy Factor of .82 for Natural Gas and Propane Certified for Installation in Manufactured (Mobile) Homes Leak detection shuts off water to unit to limit property damage Enhanced scale detection lessens possibility of serious, long-term damage to unit Temperature lock prevents accidental or unauthorized changes to water temperature Complies with South Coast Air Quality Management District 14 ng/J or 20 ppm NOx emission levels Rinnai Value Series Tankless Water Heater Product Warranty Dimensions Width: 14 Inches Height: 23 Inches Depth: 9 Inches Weight 45.6 Pounds Ignition Direct Electronic Hot Water Capacity 0.26 to 6.6 GPM Minimum Activation Rate 0.4 GPM Minimum/Maximum Gas Rate (Input BTUs ) 10,300 150,000 Energy Factor 0.82 for Natural Gas and Propane Energy Star Yes Approved Gas Types Natural Gas or Propane Temperature Settings 98F – 140F with MC-91-2US 98F – 160F with MCC-91-2US Type of Controller MC-91-2US (included) MCC-91-2US (optional for Hydronic Applications) MC-100V-1US Deluxe Controller (optional) BC-100V-1US Bathroom Controller (optional) Ultra Lox NOx Yes Electrical AC 120 Volts, 60 Hz Electrical Consumption Normal: 76 Watts Standby: 2 Watts Anti-Frost Protection: 120 Watts Service Connections Gas Supply: 3/4 Inch MNPT Cold Water Inlet: 3/4 Inch MNPT Hot Water Outlet: 3/4 Inch MNPT

Product Description

This Smart Technology electric tankless water heater is configured as a “whole home” model for climates where incoming water temperature is 67°F and above. This model is well suited for heating up to 2-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 67°F and an output setting of 105°F. Digital Temperature Control allows you to set your temperature in increments of 1 Degree. This model can also be used in colder climates as a Point of Use for a sink or other low flow application. All tankless water heaters are sized based on flow rate and temperature rise, and there is a direct relationship between the two. So if used in a cold area requiring a high temperature rise, it will be more limited in the amount of fixtures (gallons per minute) it can heat at one time compared to a warmer climate. When sized properly this water heater will provide endless hot water and only consume the energy needed, giving the user complete control. Prior to purchase and installation please verify this model is the right size for the expected demand and electrical requirements. The ECO 11 requires a minimum 125 amp electrical panel for installation with (1) 60 amp double pole breaker connected to (1) set of #6 awg wire. Plumbing connections are 1/2″ compression fitting with the option of 1/2″ NPT adapter included. For additional assistance please feel free to contact our support center at 877-474-6473.

NOTE : 11Kw at 220 is equal to 13kw at 240.

From the Manufacturer

This Smart Technology electric tankless water heater is configured for climates where incoming water temperature is 67 Degree F and above. This model is well suited for heating up to 2-Gallon per minute, which is the equivalent of one shower head (with a 1.5 gpm flow) and one sink with a low inlet water temperature of 67 Degree F. Digital Temperature Control allows you to set your temperature in increments of 1 Degree. This model can also be used in colder climates as a Point of Use for a sink or other low flow application. Prior to purchase and installation please verify this model is the rights size for your hot water needs and electrical requirements.

120V – requires hard wiring. 1440W element. Magnesium anode rod. Rectangular shape with 2″ of foam insulation. Glass lined tank for longer life. 6 year warranty on heater and 1 year warranty on parts for both commercial and residential use. Temperature/pressure relief valve included. Can be mounted both horizontally or vertically. Mounts on floor or wall. Meets ASHRAE 90.1. See Info Page for technical and installation specifications.

This compact , yet powerful unit – with gas inputs up to 140,000 BTU per hour – can meet all the hot-water needs of a small to medium American home or apartment. Designed to virtually do anything a 40-gallon tank-type water heater can do and much more The Wall mounted Excel Pro is design to work with hydronic baseboard or radiant floor heating applications, as well as provide domestic hot water to plumbing fixtures and appliances. LCD Display Control: Just set the desired water temperature The Excel Pro has an energy factor of 0.84-0.85. Excel Pro: Modulating Technology Tankless water heaters can be further divided into two categories according to their heating capability: “full on/full off” versus “modulating”. Full on/full off units do not have a variable power output level; the unit is either fully on or completely off. This can cause an annoying and possibly hazardous variation of hot water temperature, as the flow of water through the heater varies. Modulated tankless water heaters change their heat output in response to the flow rate of water running through the unit. The Excel Pro comes with a display panel where you can set the output temperature and regardless of water flow the unit modulates the fire power. Pure Copper Heat Exchanger * As used by other top of the line tankless gas water heater manufacturers like Rinnai, Takagi, Rheem and Noritz. Features & Benefits Super compact 14.5″ x 23″ x 5.5″ size 84%+ thermal efficiency 140,000 BTU maximum input 6.6 gallons/ minute capacity at 35F degree rise Minimum activation flow rate of 0.5 gpm Electronic ignition. Has a Power vented fan that Vents directly vertically or horizontally with 3” stainless steel flue 3′ long flue and elbow included. Can be used in recirculation and space heating application . Delivers 6.6 gpm of hot water with a 35°F Instant Temperature Rise (Equivalent to 5.5gpm with a 45F temp Rise). European Model Digital Display is in Celsius.

PLEASE READ BEFORE PURCHASE. Part Numbers are Interchangeable. Water Heater FVIR (Flammable Vapor Ignition Resistant) or FTR Fixed Thermal Release for FVIR or FV or TRD system (Flammable Vapor Ignition Retardation System). Product is compatible with Rheem, Ruud, Richmond, GE, and other water heaters. This item has various part numbers which interchange variably between different makes and models of your water heater. Installation instructions may be found online or through the manufacturer of the water heater. The image is an example of the interchangeable part that you will receive. This product may have a different “AP” number associated then the one in your water heater. Please message seller directly with any questions or concerns prior to purchasing.

Conclusion

By our suggestions above, we hope that you can found gas hot water tanks for you.Please don’t forget to share your experience by comment in this post. Thank you!