dailyspect 
Nowadays, there are so many products of heating wrap for pipes in the market and you are wondering to choose a best one. You have searched for heating wrap for pipes in many merchants, compared about products prices & reviews before deciding to buy them.
You are in RIGHT PLACE.
Here are some of best sellings heating wrap for pipes which we would like to recommend with high customer review ratings to guide you on quality & popularity of each items.
HEATIT HISD 3-feet Pipe Heating with Built-in Thermostat, Black
- Use for water filled plastic (including PEX) or metal pipes. Not use for anything else, like empty water pipes, fuel lines, hoses, gutters, steam lines and so on. Two year limited quality . If you are not completely satisfied with HEATIT heating cable, please don’t hesitate to contact our customer service in any time, we’ll try our best to solve your issues.
- Pre-assembled easy to install. Including grounded plug with light, built in thermostat, and instructions. Easy to install and use. 120 volt, 7 watts/ft. Built in thermostat to turn the cable 37F on 50F off. Only use 5 amps or less of electricity. Energy saving. 100% screen rate with the Aluminum foil and tinned copper braid.
- Both CSA and ETL approved. Industrial grade heat shrinkage tube for connection. Tough XLPE as inner insulation and weather resistant PVC (high-low temperature) as out jacket.
- Maximum 1/2 in fiberglass insulation was used over the heating cable for lower temperature protection. Pipes must be at least 3 feet and at least 3/8” and less than 1 1/2” in. diameter. No crossing. No spiral. No overlap itself. Only straight.
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. To avoid the overheat, please don’t plug in the cable for a long time for testing. When you feel the slight warm, please turn it off.
- Copper
Similar items with 4 stars and above
WRAP-ON Pipe Heating Cable – 3-Feet, 120 Volt, Built-in Thermostat, Low Wattage – 31003
- BUILT-IN THERMOSTAT – Turns the cable on at 38 degrees F and prevents frozen pipes to -50 degrees F – Simply wrap on, insulate and plug in. Insulation sold separately.
- PRESS-TO-TEST BUTTON – Exclusive feature to test cable before or after installation.
- ENERGY EFFICIENT – Uses up to 65% less energy at 2 watts per foot vs other cables at 7 watts per foot.
- USE ON ALL RIGID PIPES – PVC, CPVC, copper and metal pipes.
- MADE IN THE USA
Product Description
Prevents frozen water pipes to –50F. Simply wrap on, insulate and plug in. Engineered for use on metal and rigid plastic pipes. Uses an exclusive Press-To-Test button so you can test the cable before installing. A built-in thermostat turns the cable on at 38F. Proven low-wattage design uses up to 65 percent less energy at 2 watts a foot vs. other cables at 7 watts a foot, and protects to –50F. An exclusive power sensor light glows when the thermostat is closed. Each package contains one ready-to-install pipe heating cable along with installation instructions. To install, you will also need PVC/electrical tape, fiberglass pipe insulation, a tape measure and eye protection. Warning: This cable has been designed for the sole purpose of preventing metal and rigid plastic water filled lines from freezing. DO NOT use this product on fuel lines, drain lines, hoses or buried pipes. Fiberglass pipe wrap is required to complete the installation. Read and follow all instructions. Cables are available in various lengths. See chart to determine the length required for your application.
From the Manufacturer
Pipe Heating Cable – 31003 3Ft. Ul Pipe Heating Cable
Similar items with 4 stars and above
HEATIT JHSF 120-feet 120V Self Regulating Pre-assembled Pipe Heating Cable
- JHSF doesn’t work unless the ambient temperature is below 37F/3 degree C. Please test the cable in a cold environment. HEATIT is registered Trademark by zhukeshi(We didn’t authorize other sellers in Amazon.com).
- Suitable for use on plastic and metal water pipes.( including inlet pipe,drain pipe, sewer , palm tree frost protection etc). Self regulating heating cable output will adjust automatically based on the ambient temperature at each point along the cable. No worry about the overheat risk. More Safe. Can be used by straight, spiral and overlap. More functional.
- Pre-assembled, easy to install. Including grounded plug with light, built in thermostat(turn the cable 37F on 50F off), and instructions. 120 volt, 3 watts/ft at 50 degrees F. Energy-efficient. Protect pipes up to 2″ in diameter. For a better freeze protection, at least 1/2 inch thick insulation material is recommended, especially for extremely cold weather.
- ETL approved. 2 ft 18/3 cold lead with plug. Industrial grade heat shrinkage tube for connection.The lowest installation temperature of this heating cable is -10 degree C. The minimum bending radius is 1 inch.Tough XLPE as inner insulation and weather resistant PE (high-low temperature) as out jacket. Ingress Protection 65. Durable
- Testing the cable before the installation. Uncoil the cable, plug in the heating cable and then put the thermostat part of the cable into an ice bucket for few minutes. When the temperature is below 37F, the thermostat will energize the cable to work. Normally you can feel the slight warm on the heating cable in few minutes. Four year limited warranty. If you are not completely satisfied with HEATIT heating cable, please feel free to contact us in any time, we’ll try our best to solve your issue
Duck Brand 1285244 Pipe Wrap Insulation for Hot or Cold Pipes, 3-Inch Wide x 1/11-Inch Thick x 25-Feet
Product Description
Protecting pipes can prevent energy loss and help you save on energy bills. Duck Brand Foam Pipe Covers are great for insulating both hot and cold pipes, preventing them from winter freezing and summer sweating. Made from plastic fiber, this wrap provides the same insulating value as fiberglass without the need for gloves or masks. Use together with other Duck Brand weatherization products to make your home more comfortable and energy efficient all year long.
Amazon.com
Protecting pipes can prevent energy loss and help you save on energy bills. Duck Brand Foam Pipe Covers are great for insulating both hot and cold pipes, preventing them from winter freezing and summer sweating. Made from plastic fiber, this wrap provides the same insulating value as fiberglass without the need for gloves or masks. Use together with other Duck Brand weatherization products to make your home more comfortable and energy efficient all year long.
Heat Cable for Pipe Freeze Protection, 24 feet, with Built-in Thermostat and 16 Feet of High-Temp Installation Tape, Heavy-Duty, Self-Regulating, 120 volt
- THIS CABLE WILL NOT TURN ON UNLESS IT IS IN A COLD ENVIRONMENT. We’ve received a couple bad reviews from people testing the cables in their living rooms. Please don’t be that guy.
- AMERICAN SUPPORT: Knowledgeable, Minnesota-based company with expert support staff you can actually speak to! We are excited to help with your installation questions. Email us at [email protected]
- TAPE INCLUDED: 16 feet of high-temperature glass cloth tape is included with this cable.
- HEAVY DUTY: Integrated thermostat turns cable on at 37 degrees, off at 50 degrees, greatly reducing energy waste. Cable is 8mm wide and includes a 24” unheated cord (add to stated cable length). Cable has commercial-grade outer jacket for long life and carries a FOUR YEAR WARRANTY, which is double the warranty of similar cables on Amazon. Will not short or burn out if cable is overlapped.
- USES: Use on the inside or outside of all types of water carrying pipe including copper, steel, PVC, ABS, PEX, concrete and more
- can be exposed directly to water and is rated for soil contact.
THIS CABLE WILL NOT WORK unless it is in a cold environment. We’ve received a couple bad reviews because people ‘tested’ the cable in their warm living room. Eye roll. Please don’t be that guy. The built-in thermostat will NOT TURN THE CABLE ON unless it is in a cold environment. Now for the good news, this kit includes 16 feet of high temperature glass cloth tape for installing your cable. Pipe Freeze Pro is a commercial-grade, self-regulating heat cable which provides years of reliable freeze protection for pipes of all varieties, including copper, steel, PVC, ABS, PEX and more (pipe diameters up to 2”). It may also be used in drains and culverts through the winter months to promote drainage. Don’t buy from companies without a human available by phone. Heat cable is technical stuff and it’s great to have solid advice on how to install it. We are the only heat cable seller on Amazon who is a simple phone call away. Eat that off shore competitors! Pipe Freeze Pro is jacketed with a commercial-grade fluoropolymer and comes standard with a flame-retardant thermoplastic interior jacket. Our 16 gauge heating wires are 200% thicker than the conductors found in cheap, constant wattage cables like EasyHeat and Frost King. Thicker conductors mean greater heating efficiency, more melting power and long term cable integrity. Pipe Freeze Pro is self-regulating, meaning it ‘asks’ for more energy as it gets colder outside and less energy when it’s warmer. The entire length of our cable is temperature sensitive such that colder areas demand more power than warmer areas. Smart stuff. The stated cable length DOES NOT include an additional 24” unheated cold lead. For example, a 6 foot cable is 6 feet plus 2 feet of unheated cord. Installation is simple. Run Pipe Freeze Pro along the pipe, secure with fiberglass cloth tape (included) every 12 inches and wrap with standard pipe insulation. Read the manual for full instructions, of course.
Similar items with 4 stars and above
VIVOSUN Insulated Spiral Pipe Wrap Insulation Bubble Film 6-Inch by 25-Feet
- Simply wraps around your pipes or duct work overlapping approximately 1/2-Inch as you go.
- Provides an air space between the pipe and the wrap that will aid the insulation value.
- Secure with foil tape around each end of your wrapped product.
- Used for the internal or external pipes, like the exhausting hose of a AC.
M-D Building Products 4325 M-D 0 Pipe Heating Cable, 6 Ft L
- This item is a M-D Building Products 4325 6-Foot Pipe Heating Cable with Thermostat
- Purpose of use for Rough Plumbing, pipe-heat-cables
- This product is manufactured in China
- Prevents frozen water pipes to -50°F
- Easy to install just “wrap around” application
- Sensor light shows thermostat is working
- Available in 6 different lengths
- Built in thermostat
This M-D Building Products 6-Foot Pipe Heating Cable with Thermostat is UL- and CSA-approved and designed to prevent water line freeze up. Ready to install, grounded cord and plug, thermostat controlled, with pilot light. Recommended for use on metal and rigid plastic pipes. Exclusive Press-To-Test button test cable before installing! The built-in thermostat turns cable on at 38 Degree F. Reliable low wattage design uses up to 70% less energy than other cables and protects to -50 Degree F! Wrap around not needed.
Wrap-On SEPTLS34731006 – Pipe Heating Cables
Product Description
Prevents frozen water pipes to –50F. Simply wrap on, insulate and plug in. Engineered for use on metal and rigid plastic pipes. Uses an exclusive Press-To-Test button so you can test the cable before installing. A built-in thermostat turns the cable on at 38F. Proven low-wattage design uses up to 65 percent less energy at 2 watts a foot vs. other cables at 7 watts a foot, and protects to –50F. An exclusive power sensor light glows when the thermostat is closed. Each package contains one ready-to-install pipe heating cable along with installation instructions. To install, you will also need PVC/electrical tape, fiberglass pipe insulation, a tape measure and eye protection. Warning: This cable has been designed for the sole purpose of preventing metal and rigid plastic water filled lines from freezing. DO NOT use this product on fuel lines, drain lines, hoses or buried pipes. Fiberglass pipe wrap is required to complete the installation. Read and follow all instructions. Cables are available in various lengths. See chart to determine the length required for your application.
From the Manufacturer
Pipe Heating Cable – 31006 6-Foot Ul Pipe Heating Cable
M-D Building Products 4309Pipe Heating Cable with Thermostat, 3-Foot
- This item is a M-D Building Products 4309 3-Foot Pipe Heating Cable with Thermostat
- Purpose of use for Rough Plumbing, pipe-heat-cables
- This product is manufactured in China
- Prevents frozen water pipes to -50°F
- Easy to install just “wrap around” application
- Sensor light shows thermostat is working
- Available in 6 different lengths
- Built in thermostat
Product Description
This item is a M-D Building Products 4309 3-Foot Pipe Heating Cable with Thermostat. Purpose of use for Rough Plumbing, pipe-heat-cables. This product is manufactured in China.
From the Manufacturer
M-d building products 04309 3′ pipe heating cable with thermostatm-d building products 04309 3′ pipe heating cable with thermostat features: ul and csa approved pipe heating cable designed to prevent water line freeze up ready to install, grounded cord and plug, thermostat controlled, with pilot light 3′. No wrap needed.
Conclusion
By our suggestions above, we hope that you can found heating wrap for pipes for you.Please don’t forget to share your experience by comment in this post. Thank you!
